Android 7.0 Nougat AOSP ROM For AT&T LG G2 D800

0
1684
Android 7.0 Nougat AOSP ROM For AT&T LG G2 D800
Android 7.0 Nougat AOSP ROM For AT&T LG G2 D800

Good news According to XDA Member xdahero1 Android 7.0 Nougat AOSP ROM is now available for AT&T LG G2 D800.

ROM 
AOSP is Android as Google publish without other modifications. More or less AOSP is the Nexus devices stock rom without gapps.

Working and not working list:
RIL – no
WIFI – yes
BT – yes
HW – yes
AUDIO – yes
VIDEO PLAYBACK – yes
NFC – yes
CAMERA – no
SENSORS – yes?


Thing To Know

  • This Android 7.0 Nougat AOSP ROM is meant for only AT&T LG G2 D800. Please do not try on any other Sony Xperia Variants.
  • You are going to use Twrp Recovery to flash this NanoROM ROM on your phone.
  • Sony PC Companion will NOT detect your phone after installing this ROM because it is a custom firmware.
  • This Rom will wipe out all your data. Make sure you backup all your data in your phone before proceeding.
  • Perform a Dalvik Cache wipe before proceeding from the Recovery Mode.

Important:
Backup important files stored on your device before proceeding with the steps below, so that in case something goes wrong you’ll have backup of all your important files.

How To Flash Nougat 7.0 ROM Via TWRP

  1. Download Nougat 7.0 ROM Custom firmware to your PC
  2. Connect your device to the computer
  3. Place the Nougat 7.0 ROM into the phone’s storage
    memory you are advised to paste the .zip file in the storage root
    folder, not in any other folder
  4. Turn off the device and disconnect it from PC
  5. Perform Recovery mode sorties by long pressing Volume (Down) + Power buttons
  6. Once entering the TWRP settings menu, clear phone’s memory (full) by selecting the ‘Wipe’ option. Once done, select – ‘Swipe to Factory Reset’ perform a factory reset
  7. 7: Return to TWRP settings and tap ‘Install’ by the selecting.Zip file in the phone’s memory downloaded from PC
  8.  Come back to TWRP menu setting to approve the installation by tapping ‘Swipe to Confirm Flash’
  9. Flashing of the custom ROM begins and after a few minutes, a message ‘Successful’ appears on the screen, thus completing the installation
  10. If faced with boot loop problem, navigate back to TWRP settings, and select ‘Wipe cache/dalvik’. This procedure will help resolve any issue with regard to custom ROM installation.

DOWNLOADS

LEAVE A REPLY

Please enter your comment!
Please enter your name here